1. Product technology and use:

    Aluminum foil anticorrosion belt is a new type of external anticorrosion material with high self-adhesive and strong anti-ultraviolet ability. The base of the product is toughened aluminum foil sheet, rubber layer is made of butyl rubber modified asphalt, covered with a layer of anti-stick isolation film.

    This product is mainly used in natural gas, petroleum, chemical, pharmaceutical, heat, urban construction of oil, gas, water, heating overhead pipeline or tower structure corrosion protection. The product is made of aluminum foil base material with unique reflection of sunlight and strong uv resistance and flexibility, smooth appearance and butyl rubber modified asphalt adhesive with high anticorrosion and strong adhesion. Solid aluminum foil anti-corrosion adhesive tape has waterproof, anti-aging, no curing, no cracking, no long-term movement, no stripping and other excellent characteristics, so as to achieve strong anti-corrosion ability, beautiful appearance effect, the product has been verified by practice is an excellent and beautiful anti-corrosion products.


   2. Performance indicators

Serial numberProject nameUnitParameter
1Color appearanceSilvery white flash
 2Thickness of base film mm 0.03-0.10
 3Bondline thickness mm 0.60-2.00
 4Aggregate thickness mm 0.63-2.10
 5Tensile strengthMpa ≥100
 6Elongation at break % 150
 7Sheering PropertiesOn the backN/25mm ≥50 Or glue
Aluminum plateThe fracture
 8Stripping performance N/25mm≥40
 9Low tender degrees(-10℃,20mm,3s,180o)There is no crack
 10Heat resistance (120℃)non-slip
 11Dielectric strength Mv/m ≥25
 12Volume resistivity Ω.M 2×1010
 13 Water vapor transmittance(24h) Mg/cm 2 く0.45
 14Bibulous rate % ≤0.35
 15Thermal resistance ℃-34——+110 

3. Usage:

(1), surface treatment: rust removal, welding slag, burr, oil, dirt and keep clean and dry, manual rust removal should reach St3 level, mechanical rust removal should reach Sa2 level, and meet the requirements of SYJ4007 86.

(2), primer: special primer should be used, away from the fire when used, stir evenly and clean brush, roller or other mechanical methods evenly coated, primer dosage: manual coated 12 / L mechanical coated 20 / L, (3), until the primer table dry 5-10 minutes can be wound.

(4) The operating temperature -5℃ - +50℃.

4. Transportation and storage:

(1) Prevent exposure to sunlight, rain, freezing and heat preservation, prevent crushing deformation, prohibit close to heat source and open fire.

(2) When transporting or storing, it shall be carried out in an environment of -20℃ to +35℃.

(3) The shelf life is 6 months.

c4.jpg        c5.jpg        c6.jpg

All rights reserved © 2016 Ningbo anda anticorrosive material technology co., LTDTechnical support:yingxun Network technology